08-30-2021 09:43 PM
Hello,
I tried to import Palo Alto Firewall Config to Expedition. But I didn't see ipv6 in the interface and Virtual-Route. It just shows only ipv4. and in the Security Policy and Object Address can show IPv6 normally. Do I have to Enable any Feature or It doesn't support IPv6 in the interface and Virtual-Route?
Details
Expedition Version: 1.1.106
08-31-2021 07:52 AM
Hello @jirasith
Yes, IPv6 is supported with expedition for both the interface and route. So the IPv6 exists on the Palo Alto firewall prior to import and it is not importing it properly? That would mean yes IPv6 was enabled on the firewall prior to an import and expedition will show the IPv6 address on both the interface and associated static route.
09-04-2021 11:16 PM
Hello Azuniga,
I checked in the running-config before imported to the expedition. I confirmed the running-config include ipv6 and the Palo Alto firewall already enabled IPv6. but when I imported running-config to the expedition. It did not show ipv6 on interface and Virtual-Route.
09-07-2021 08:13 AM
Hello @jirasith
Can you please take a look at the XML output and see if the IPV6 route is identified within that file? If it is indeed there then the XML should also reflect that.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
