02-28-2018 05:47 AM
After installing update 8.0.8 on a couple of our PA 3020s they became inaccessible using the web access and SSH. We had to do a factory reset on the devices. Every time we tried to put the devices back into FIPS\CC with 8.0.8 installed the devices would get stuck in a boot loop. We had to do a factory reset and reinstall version 8.0.7. Then we enabled FIPS\CC and restored the devices. We also updated our PA 5060s and had no problems at all.
I was wondering if anyone had experienced this problem? I haven't seen anything about this issue so far but I am holding off upgrading our PA 3050s for now.
02-28-2018 06:59 AM
Hello,
I would open a support case and update here as well. Sounds like something could have gone awry with the upgrade?
Regards,
03-29-2018 07:12 PM
I have 2 - PA5050 having the same issue. TAC has been unable to determine the cause. Had to factory reset one and reinstall 8.0.8 and the other one I was able to roll back to 8.0.6 h3.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
