SNMP RFC 1213 (MIB-II) and RFC 2664 (EtherLike-MIB)

cancel
Showing results for 
Search instead for 
Did you mean: 

SNMP RFC 1213 (MIB-II) and RFC 2664 (EtherLike-MIB)

Not applicable

Hardware: PA-500

Firmware: 4.0.2

Page 17 of the PAN 4.0 Admin Guide says:

"Simple Network Management Protocol (SNMP)—Supports RFC 1213 (MIB-II) and RFC
2665 (Ethernet interfaces) for remote monitoring, and generates SNMP traps for one or
more trap sinks (refer to “Configuring SNMP Trap Destinations” on page 54)."

But yet when I do an snmpwalk I do not see any MIB's for RFC 1213 (MIB-II) or RFC 2665 (EtherLike-MIB).

The MIB's that do show up are HOST-RESOURCES-MIB, IF-MIB and SNMPv2-SMI.

On my Cisco and HP routers I get RFC1213-MIB and EtherLike-MIB with an snmpwalk and lots of them.

Is anyone else having this problem? Can anyone see RFC 1213 or RFC 2665 MIB's when they do an snmpwalk?

1 ACCEPTED SOLUTION

Accepted Solutions

L6 Presenter

@oneloveamaru:

The Palo Alto Networks implementation does not implement every feature described in the RFCs that you cite.

If you wish to see more features of these RFCs implemented I encourage you to talk to your sales team and have them file a feature request.

Thank you,

Benjamin

View solution in original post

3 REPLIES 3

L6 Presenter

@oneloveamaru:

The Palo Alto Networks implementation does not implement every feature described in the RFCs that you cite.

If you wish to see more features of these RFCs implemented I encourage you to talk to your sales team and have them file a feature request.

Thank you,

Benjamin

View solution in original post

I wish the Admin Guide would say limited support then.

Also, if anyone searches for this, the reason those MIB names don't come up is because PAN is calling them something else. If you run the OID manually from either RFC1213 or RFC2664, it'll come back but named IF-MIB.

Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!