Core content from the show running resource-monitor command on a VM series firewall

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Core content from the show running resource-monitor command on a VM series firewall

L0 Member

The show running resource-monitor outputs the load rate for each core in the cpu usage part.
It is evenly distributed in each core, so there is a case where there is no load factor, but only one output.
At this time, I would like to know if the output to only one is really the load rate generated from that core or the load rate generated from all cores combined into one and output.
And I would like to know if the output of only one is due to the equipment structure.

Dasome_Kim_0-1711527775435.png

 

1 accepted solution

Accepted Solutions

Cyber Elite
Cyber Elite

On a regular dataplane it could be possible that one core is high while other cores are low if for example a single flow requires a lot of processing (high pps, encapsulation, ...)

Flows in the dataplane are assigned to a core for processing, so a single session will use a single core during it's lifetime

 

In the screenshot above, however, core 1 is used by the management plane

Tom Piens
PANgurus - Strata specialist; config reviews, policy optimization

View solution in original post

1 REPLY 1

Cyber Elite
Cyber Elite

On a regular dataplane it could be possible that one core is high while other cores are low if for example a single flow requires a lot of processing (high pps, encapsulation, ...)

Flows in the dataplane are assigned to a core for processing, so a single session will use a single core during it's lifetime

 

In the screenshot above, however, core 1 is used by the management plane

Tom Piens
PANgurus - Strata specialist; config reviews, policy optimization
  • 1 accepted solution
  • 1818 Views
  • 1 replies
  • 0 Likes
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!