Expedition to migrate between two different PA FW models?
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

The Enhanced LIVEcommunity Experience is finally here! Learn all about it.

Expedition to migrate between two different PA FW models?

L1 Bithead

We are upgrading into newer/faster firewall models, and I am curious if the Expedition tool could be used to re-map the old firewall physical interfaces identifiers to the new firewall interface identifiers?

 

Or, is there an easier process to maintain our FW configurations while upgrading into a new firewall hardware model.

 

OLD            NEW

ethernet1/3    ethernet1/6

ethernet1/2    ethernet 1/3
etc.

 

Thank You,

~Eric

 

1 ACCEPTED SOLUTION

Accepted Solutions

L0 Member

I found it was easier and faster to use good old sed to quickly swap out interface names between a 5060 and 5260 config.

View solution in original post

2 REPLIES 2

L0 Member

I found it was easier and faster to use good old sed to quickly swap out interface names between a 5060 and 5260 config.

View solution in original post

That's what we finally did. Thanks for your reply!

Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!