Can PA recognize user-id from AD using TAP-mode?
cancel
Showing results for 
Search instead for 
Did you mean: 

Can PA recognize user-id from AD using TAP-mode?

L3 Networker

Hi All.

I tested that PA with AD using TAP-mode.

AD-agent, CLI at PA device could recognize users from Active-Directory. but Traffic logs, Threat logs, URL logs could not recognized user-id and session-browser showed user filed was unknown.

I think that PA could not recognize user-id from AD using TAP-mode. is it right?

Please answer about above.

Thanks.

Regards.

Roh.

3 REPLIES 3

Not applicable

Hi Ron,

It supports User-ID using TAP mode. Please verify that you already enable user identification on source zone and destination zone. Hope this help.

Regards,

Johnny

L7 Applicator

Hi Roh

can you also check your security policy, it should be

source tapzone destination tapzone action allow

(and as indicated by johnny, make sure user identification is enabled on the tapzone)

Tom Piens
Like my answer? check out my book! https://bit.ly/MasteringPAN

Hi all

Thank you. I missed configuration for user-identification at tap zone.

Best Regards.

Roh.

Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!