Configure Firewall HA through Panorama

Reply
Highlighted
L1 Bithead

Configure Firewall HA through Panorama

Hi !

 

How we can configure the HA between Firewall through Panorama. I have added the both devices in to single device groups. So whenever i did the HA configuration parameters it's getting applied to both devices .

 

What are the steps need to be followed for this ?

 

Thanks in Advance...

Highlighted
L2 Linker

Not sure if its the correct way but the HA settings, the management IP, and the host name are the only things I do manually on each firewall rather than through panorama. 

Highlighted
Cyber Elite

@gpsriram,

Usually HA is done before the devices actually connect to Panorama. Either manually by the admin as @dstjames stated, or during the boostrap process. Personally I always use the bootstrap process, but unless you're deploying a large number of firewalls or deploying firewalls often it might not be worth it to you to do this. 

HA to the best of my knowledge is considered to be a part of the Intial Configuration process, and therefore can't be setup by Panorama. 

Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the Live Community as a whole!

The Live Community thanks you for your participation!