This website uses Cookies. Click Accept to agree to our website's cookie use as described in our Cookie Policy. Click Preferences to customize your cookie settings.
HA1 showing down
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- LIVEcommunity
- Discussions
- General Topics
- HA1 showing down
Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Printer Friendly Page
HA1 showing down
Options
- Mark as New
- Subscribe to RSS Feed
- Permalink
06-11-2020 07:12 AM
HA1 is showing down, but HA1 Backup and HA2 are showing up. FWs recently configured by contractor who has left. Configuration appears correct. Any suggestions?
19 REPLIES 19
Options
- Mark as New
- Subscribe to RSS Feed
- Permalink
06-11-2020 08:02 AM
Was it ever up? Any changes if it was up? Have you tried a cable replacement?
Are they directly connected or going through a switch?
You said the config looks fine. Did you verify the ha1 IP addresses on both members are in the same subnet and correctly defined on each other?
Options
- Mark as New
- Subscribe to RSS Feed
- Permalink
06-11-2020 11:53 AM
To my knowledge it was never up. The contractor who set it up left abruptly and we never had time to circle back and discuss. He did say that he needed to change something but didn't say what and from what I can tell the HA config was done correctly. The five pairs are directly connected, however two of the pairs are on different subnets. I'm not sure why he set them up differently. The Peer HA1 IP address on the active Palo is the IP of the passive Palo, and the Peer HA1 IP address of the passive Palo is the IP of the active Palo - is that what you are referring to?
Options
- Mark as New
- Subscribe to RSS Feed
- Permalink
06-11-2020 01:38 PM
What are the 5 pairs that are connected? HA1-a, HA1-b, hsci and the Aux ports? What is each being used for?
What model firewalls are these?
In the CLI, does that HA interface show up?
Are the HA1 addresses on the same subnet?
Options
- Mark as New
- Subscribe to RSS Feed
- Permalink
06-11-2020 03:31 PM
What are the 5 pairs that are connected? HA1-a, HA1-b
What model firewalls are these? PA-850
In the CLI, does that HA interface show up? show interface command will not work in the CLI
Are the HA1 addresses on the same subnet? Yes
Related Content
- Server-Monitoring shows Authentication-failed or Connection refused error in General Topics
- Need to Allow user to uninstall Global Protect with a Password in GlobalProtect Discussions
- Server Monitoring of User-ID agent set-up shows Authentication failed /Connection refused error in General Topics
- Global Protect in General Topics
- Yara Rules error in Cortex XSOAR Discussions
Like what you see?
Show your appreciation!
Click Like if a post is helpful to you or if you just want to show your support.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
LEGAL NOTICES
Copyright 2007 - 2023 - Palo Alto Networks