Inline PA vwire on inside interface of Cisco ASA HA/pair inline

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Announcements

Inline PA vwire on inside interface of Cisco ASA HA/pair inline

Not applicable

I am currently running a pair of Cisco ASA 5520 in HA.   I want to protect the traffic going inside with an inline wire on the inside interface of Cisco ASA HA/pair as it travels to the LAN.  A pair PA-2020 are configured in Active/Standby with the wire trust/untrust pairs running inline after the ASA HA pair.  Untrust zone going to the ASA and trust zone going into the LAN.  The PA standby Passive Link State is set to Auto however the Cisco ASA is not seeing the inside heartbeat traffic on the standby unit come up.  Is this because the standby unit is not passing traffic?  Should I configure the PA pair as an Active/Active pair where both vwire config and policies are passing traffic?

1 REPLY 1

Not applicable

Think I found it, Active/Active HA vwire.

  • 2339 Views
  • 1 replies
  • 0 Likes
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!