Is there a global "enable SNMP" switch?

[rkra]

I'm trying to get some data about the amount of data on the interfaces.

Device/ Operations/ SNMP configured, SNMPV2 enabled.

SNMP on my Trust interface per IF Profile enabled.

I still can not get SNMP Data.

Roman

[hshah]

Hi Rka,

SNMP configuration is for whole device. Once its enabled properly it should give information of whole device. Following documents  would be helpful.

https://live.paloaltonetworks.com/search.jspa?q=snmp&type=document

Regards,

Hardik Shah

[HULK · Accepted solution]

Hello rkra,

Please find below few key documents for your reference:

How to Configure SNMPv2

How to Verify SNMP Functionality

Supported MIBs

Hope this helps.

Thanks

[ssharma]

Hi Roman,

Based on the SNMP software that you are using, you might have to specify SNMPv2 and community strings. These values are under "Options" section.

Also Layer 3 connectivity is important and make sure you don't have deny any any policy at the bottom from trust-2-trust traffic. Look for "show session " information for source IP of the machine that is doing snmp walk. Hope this helps.