Is there a way to copy partial configs?

[erantanen]

If I had a cisco, I could copy/paste partial configs between devices, is there away to do this with the PA?

I have some tunnels that need to get built across several firewalls, but I dont want to go to each one.

[mikand · Accepted solution]

You mean in CLI?

You can use the "set cli" command to change output format into set-commands (for export) along with turning of confirmation prompt (for import):

set cli
{
config-output-format {default | set | xml} |
confirmation-prompt {off | on} |
hide-ip |
hide-user |
pager {off | on} |
scripting-mode {off | on} |
terminal {height <value> | type <value> | width <value>} |
timeout idle {never | value>}
}

> config-output-format — Sets the output format for the configuration file to the default, XML format, or set
command format
> configuration-prompt — Enables or disables presentation of a confirmation prompt for some configuration
commands
> hide-ip — Hides the last octet of the IP address in logs
> hide-user — Hides user names in logs
> scripting-mode — Toggles scripting mode (scripting mode will modify the CLI output such that special
characters used for formatting are suppressed)
> pager — Enables or disables pagers
> terminal — Sets terminal parameters for CLI access
> height — Sets terminal height (1-500)
> type — Sets terminal type (press <tab> for list)
> width — Sets terminal width (1-500)
> timeout — Sets administrative session timeout values
+ idle — Idle timeout (never or 0-1440 minutes; default = 60 minutes)

[nvargas]

Very good, thanks for inte info.