L3 configuration

Reply
sib2017
L4 Transporter

L3 configuration


Hi,

Distribution switch with multiple vlan created L3 interfaces .

Multiple Edge switch connected with distribution switch via L2 trunk .

if i have vlan 2 -10 configured with respective L3 interfaces like 10.0.2.1,10.0.3.1..10.0.10.1 , and i want to monitor traffic between these vlan

How can i configure ?
How the physical toplogy and logical toplogy look like .

Thank you

 

 

 

pankaku
L5 Sessionator

You have to make sure that traffic among those VLAN passes through the PA firewall then only you can monitor and apply policies.

 

If the switch have SVI then the traffic will direclty move between the vlan it will not pass through the firewall. One thing you can try is to create the L3 subinterfaces on the firewall and remove the SVI from the switch.

 

2015-12-27_18h43_47.png

 

By default the intrazone traffic is allowed and you will not get logging so to log the traffic you have to create security policy as well to log the traffic and to have better control over the traffic.

 

The link between switch and PA should be a trunk link if you are creating subinterfaces on PA.

 

Hope this helps!

 

reaper
L7 Applicator

Hi

 

Please take a look at the Getting Started — the Series where we've highlighted Layer3 subinterfaces and Layer2 interfaces

 

 

regards

Tom

Tom Piens - PANgurus.com
Like my answer? check out my book! amazon.com/dp/1789956374
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!