Layer 2 MPLS pseudowire to span HA ports across sites.

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Layer 2 MPLS pseudowire to span HA ports across sites.

L2 Linker

Hello, 

I'm still learning PA and I'm planning to create a pair in HA Active/Passive mode. 

I was planning on connecting HA1A, HA1B and HA2 to a Cisco switch. Each port on a different VLAN. I was then going to trunk this traffic to a Cisco router (ASR920). I'm then planning to link two sites using layer 2 MPLS pseudowire. As anyone experienced any issues using Layer 2 MPLS pseduowire to span the HA ports using vlans?

 

It's a long shot, but if anyone has tried this then any experiences shared would be appreciated. 

 

Thank you

D

1 accepted solution

Accepted Solutions

Cyber Elite
Cyber Elite

shouldn't be any isue against using pseudowire to span your HA connections (if it helps, both can be routed as well)

 

you just need to be sure your latency is low enough for the HA handshakes to not fail out, so you may also need to 'tweak' your timers a little to accomodate any latency you do have that can't be fixed

 

 

Tom Piens
PANgurus - Strata specialist; config reviews, policy optimization

View solution in original post

2 REPLIES 2

Cyber Elite
Cyber Elite

shouldn't be any isue against using pseudowire to span your HA connections (if it helps, both can be routed as well)

 

you just need to be sure your latency is low enough for the HA handshakes to not fail out, so you may also need to 'tweak' your timers a little to accomodate any latency you do have that can't be fixed

 

 

Tom Piens
PANgurus - Strata specialist; config reviews, policy optimization

Thank you Tom, that is good to hear. I will span each HA1A, HA1B and HA2, on different vlans - then trunk them together and use layer 2 pseudowire to span them across sites. And I can adjust the timers if it doesn't work. I'm a happy man!

  • 1 accepted solution
  • 2817 Views
  • 2 replies
  • 0 Likes
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!