Management ip address cannot be seen again

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Management ip address cannot be seen again

L2 Linker

Hi Management interface ip address is configured, and it could work before. but now I cannot see it. After the ip address is reconfigured(and commit), I still cannot see it. Below is its config. Anyone can take a look at it? Thank you!

 

set deviceconfig system ip-address 192.168.1.6 netmask 255.255.255.0 default-gateway 192.168.1.1

 

 

show interface management

-------------------------------------------------------------------------------
Name: Management Interface
Link status:
Runtime link speed/duplex/state: unknown/unknown/down
Configured link speed/duplex/state: auto/auto/auto
MAC address:
Port MAC address 08:66:66:66:66-

Ip address: unknown
Netmask: unknown
Default gateway:
Ipv6 address: unknown
Ipv6 link local address: unknown
Ipv6 default gateway:
-------------------------------------------------------------------------------


-------------------------------------------------------------------------------
Logical interface counters:
-------------------------------------------------------------------------------
bytes received 3629
bytes transmitted 4362
packets received 47
packets transmitted 15
receive errors 0
transmit errors 0
receive packets dropped 0
transmit packets dropped 0
multicast packets received 1

1 accepted solution

Accepted Solutions

L6 Presenter

Try to see that the DHCP is not enabled:

 

set deviceconfig system type static

 

 

Also try the command :

 

show system state filter cfg.net.s1.eth0.cfg

 

How to view Management Interface Setting in the CLI - Knowledge Base - Palo Alto Networks

 

 

 

Also is your device a palo alto VM?

 

Also check for known issues for your version:

 

https://docs.paloaltonetworks.com/pan-os/8-1/pan-os-release-notes/pan-os-8-1-release-information/kno... 

View solution in original post

3 REPLIES 3

L6 Presenter

Try to see that the DHCP is not enabled:

 

set deviceconfig system type static

 

 

Also try the command :

 

show system state filter cfg.net.s1.eth0.cfg

 

How to view Management Interface Setting in the CLI - Knowledge Base - Palo Alto Networks

 

 

 

Also is your device a palo alto VM?

 

Also check for known issues for your version:

 

https://docs.paloaltonetworks.com/pan-os/8-1/pan-os-release-notes/pan-os-8-1-release-information/kno... 

L2 Linker

Thank you! It can work!

If it does not help then shutdown and unshut the interface. I wouldn't suggest for cosmetic bug to redeploy the config that almost always helps by saving the config doing factory reset and then adding the config back. Also for info  I have seen such an issue on firewalls 3000/3200.

 

 

 

  • 1 accepted solution
  • 7125 Views
  • 3 replies
  • 0 Likes
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!