PA-220 won’t get IP from ISP.

[Gareth.Doyle]

Hey, all. I have a PA-220 that I am trying to setup on my network. I connected it up and set up the layer 3 on it, then turned my router into an AP and lost all connectivity.

Currently I have it connected to my modem on ethernet1/1, and As it is a residential connection obviously my IP is dynamic. I followed the dynamic configuration instructions as seen on the website, but my interface reports an IP of 0.0.0.0, which is where the default route points to. 

I believe it should e obtaining one from the ISP and applying it to the interface. I see ARPs for stuff over my wireless in the house,  And I see IPs being assigned, but none of it has internet connectivity. 

does anyone have any thoughts on what to look at? My current e1/1 configuration is:

(leaving out the set network interface Ethernet Ethernet1/1 layer 3 on all of it)

ndp-proxy enables no

Lldp enable no

dhcp-client enable yes

dhcp-client create-default-route yes

Thanks. 

[Ertu57]

Hi,

I have the exact same trouble.

My ISP modem is in DHCP, i got an ip from it to my laptop but not to PA-3260

I triple check every configuration step, got VR1 and only 2 interfaces on it (Layer 3)

No default gateway setup

Default Policy applied for intrazone

And still no IP for my outgoing interface 1/1

2 weeks messing up with this and really need this Firewall 😕