Palo Alto configure as access port

cancel
Showing results for 
Search instead for 
Did you mean: 

Palo Alto configure as access port

Not applicable

Hi All,

It has been sometime that i haven't touch on Palo Alto device and i want to clarify whether can i configure as access port (or called as untagged port) other than normally create L3 vlan routing?

I don't see such settings available on the configuration.

1 ACCEPTED SOLUTION

Accepted Solutions

L5 Sessionator

Yes, you can configure an interface in L2 mode without vlan tagging (access mode). Configure as L2 interface type and specify a vlan on the ethernet interface itself. Then assign the interface to a zone. That should be it. Do NOT configure a unit for the interface which would require tagging (trunk mode).

-Richard

View solution in original post

1 REPLY 1

L5 Sessionator

Yes, you can configure an interface in L2 mode without vlan tagging (access mode). Configure as L2 interface type and specify a vlan on the ethernet interface itself. Then assign the interface to a zone. That should be it. Do NOT configure a unit for the interface which would require tagging (trunk mode).

-Richard

View solution in original post

Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!