PBF state is dicard

cancel
Showing results for 
Search instead for 
Did you mean: 

PBF state is dicard

L0 Member

I have 2 internal test IPs, 172.16.16.2 and 172.16.16.3. These 2 IPs are respectively PBF, which implements different paths. And these two IPs have done two-way NAT. Map them to a public network address. 
The problem that arises now is that 172.16.16.2 can normally access an address on the external network, but 172.16.16.3 cannot be accessed. Some of the configurations I made are shown in the screenshot below. The problem I checked out was that the status of the PBF was discard. These two addresses are basically the same configuration mode. I don't know where the problem is?pbf-rule.pngpbf-config.png

1 REPLY 1

L7 Applicator
what's the output of > show session id
Tom Piens
Like my answer? check out my book! https://bit.ly/MasteringPAN
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!