Set zone to "any" in CLI

[BBartik]

How can I set the zone for a rule to any in the CLI? If I delete the from / to lines it sets it to "none" which is not valid. If I set it to "any" then it thinks "any" is the name of the zone which is also incorrect. Any ideas?

Thanks!

[Raido_Rattameister]

If you want to see how current rules are set up in cli use following commands:

> set cli config-output-format set
> configure
# show | match "rulebase security rules"

For example this will do the trick permitting any/any

set rulebase security rules "Test Rule 1" to any
set rulebase security rules "Test Rule 1" from any
set rulebase security rules "Test Rule 1" source any
set rulebase security rules "Test Rule 1" destination any
set rulebase security rules "Test Rule 1" source-user any
set rulebase security rules "Test Rule 1" category any
set rulebase security rules "Test Rule 1" application any
set rulebase security rules "Test Rule 1" service any
set rulebase security rules "Test Rule 1" source-hip any
set rulebase security rules "Test Rule 1" destination-hip any
set rulebase security rules "Test Rule 1" action allow