01-07-2019 01:44 PM
We currently have a Cisco switch and router with in our environment. The router does inter-VLAN routing for traffic coming from VLAN's (about 6) on switch; typically as in a ROAS setup. So the switch is L2 and router is L3.
Looking for a away to place the Palo Firewall transparently in between with two interfaces (eth 1/1 and eth 1/2); in vwire mode between the switch and router; so Eth 1/1 to connect to router and eth 1/2 to switch.
Due to setup at site, we couldn't change IP config on switch and router. Wondering, if this setup would work in vwire mode. If not vwire; any other mode of interface config would work?
01-07-2019 02:07 PM
It would work but be sure not to leave "Tag Allowed" blank while creating virtual wire because then it will pass through only untagged packets.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
