- Access exclusive content
- Connect with peers
- Share your expertise
- Find support resources
07-09-2021 11:05 AM
Setup VPN Global Protect DynDNS
Dear community:
Good afternoon, is it feasible to be able to configure VPN access with Global Protect, on a Palo Alto with the following scenario:
Palo Alto with:
-Public IP Dynamically ( DHCP )
-Firewall configured with the DynDNS service.
-FQDN provided by DynDNS ( vpnaccessgprotect.dynalias.net )
Please confirm if the Global Protect configuration with DynDNS services is feasible and supported.
Thank you very much to all, best regards
07-09-2021 11:42 AM
Hello,
While I havent done it, it should be possible, yes.
Regards,
07-09-2021 01:11 PM
Hello, thank you very much for your reply.
One doubt, in the configuration of the GP Portal, in the Ipv4 Address parameter, where you normally put the Public IP, in my case I have a dynamic IP with DHCP (with DynDNS services) I will have to put "NONE".
I remain attentive, thank you very much, best regards
07-12-2021 08:19 AM
Yes, this is possible, and is how I use my Palo NGFW. The IPv4 GP Portal tab will show "NONE" if interface address is DHCP, this is expected behavior.
Here's an example configuration.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!