09-11-2016 09:07 PM
Has anyone configured site to site between PA200 and V7610 netgear box which Telstra provides.
Can it be done ,any issues ????
09-12-2016 12:34 AM - edited 09-12-2016 05:08 AM
Hi,
I never done it but if the Netgear support traditional IPSec don't think you will get any issues. This is a standard protocol, so should not be any probs. But l just done some research and not sure if this router supports full IPSec options. Config guide below:
So cannot see options for IKE P1 and IKE P2 . You only able to configure gateway and PSK. And the example in the configuration guide explains how to do it between two Netgear V7610 routers. You could try to get their preconfigured IKE P1 and IKE P2 options and match with the Palo to see if it will work for you.
Thx,
Myky
09-15-2016 02:01 AM
Hi,
Try not to use SHA1 and don't forget proxy ID
V.
10-20-2016 07:51 PM
Has anyone tried configuring site to site ipsec with a netgear which doesnt have phase1 and phase2 options.
10-21-2016 01:16 AM - edited 10-21-2016 01:30 AM
Are you referring to the same router model or different Netgear? In any case, you need to make sure that device is supports traditional IPSec VPN and get from the Netgear their predefined IKE P1 and IKE P2 setting similar way as Azure of AWS provides to you.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
