Source and destination based on NAT using DHCP

Reply
L1 Bithead

Source and destination based on NAT using DHCP

Hi,

 

I am setting up a PAN device. On ethernet1/1 I have it set up to DHCP. I then will have a computer connected to ethernet1/9. I want to set up both source and destination based NAT. From what I understand in order to do this I would need to create an object. Is there any way to set up an IP based object that will be whatever the IP is that an interface got via DHCP?

 

TIA.

 

 

L7 Applicator

You can set up DDNS in the advanced tab of ethernet1/1, then create a FQDN address object you can use for NAT and security policy

Tom Piens - PANgurus.com
Like my answer? check out my book! amazon.com/dp/1789956374
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!