- Access exclusive content
- Connect with peers
- Share your expertise
- Find support resources
09-26-2017 12:51 PM
hi,
i have setup a site to site vpn between 2 palos . the tunnel is established but when one user from his PC ping continuously to a pc or a server on the other end, it looses 1 icmp after sending 10 or 15 icmps.
My concern is how do check the credibility of the vpn tunnel
what is the best way to check the tunnel, any show commands etc
Thanks
Imran (Brighton)
09-26-2017 02:48 PM
Do you see packet loss when pinging between Palo untrust interfaces or only if traffic goes over tunnel?
Assume one Palo has wan IP 1.1.1.1 and other has 2.2.2.2 then run command on 1.1.1.1
ping source 1.1.1.1 host 2.2.2.2
Dead Peer Detection config is same at both sides on IKE Gateway?
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!