For details on cookie usage on our site, read our Privacy Policy
VRRP on switches connected to PA in active and passive mode
- LIVEcommunity
- Discussions
- General Topics
- VRRP on switches connected to PA in active and passive mode
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Printer Friendly Page
- Mark as New
- Subscribe to RSS Feed
- Permalink
04-14-2019 08:26 AM - edited 04-14-2019 08:29 AM
below we have setup
Where switches and routers are running ospf.
PA has static route to the VRRP IP of the switch.
1>>Need to know is this good design to have the VRRP backup router connected to the PA active switch?
2>>Also yesterday when we reboot the router 1 during that time we lost the internet connection
Accepted Solutions
- Mark as New
- Subscribe to RSS Feed
- Permalink
04-16-2019 09:16 AM
Hello,
So from the diagram and my experience here are my replies:
1. I would swap the master and backup VRRP roles. This can be done with priorities.
2. Sounds like a routing issue in the switches/routers?
- Mark as New
- Subscribe to RSS Feed
- Permalink
04-15-2019 09:56 AM
Hello,
We block online storage. Can you past your screen shot/diagram into the message body?
Please advise,
- Mark as New
- Subscribe to RSS Feed
- Permalink
04-15-2019 03:31 PM - edited 04-16-2019 04:37 PM
here u go
- Mark as New
- Subscribe to RSS Feed
- Permalink
04-16-2019 09:16 AM
Hello,
So from the diagram and my experience here are my replies:
1. I would swap the master and backup VRRP roles. This can be done with priorities.
2. Sounds like a routing issue in the switches/routers?
- Windows User-ID Agent Disconnect After Failover in Next-Generation Firewall Discussions
- PAN 3220 setup query in General Topics
- failing back to primary FW and short loss of ISP connection in General Topics
- HA ports up when connected but HA NOT enabled? in General Topics
- Receive errors on all traffic interfaces in Next-Generation Firewall Discussions
Show your appreciation!
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
