IPSec Tunnels acting Strange

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

IPSec Tunnels acting Strange

L2 Linker

Version 11.1.4-h7

I am unsure if anyone else has experienced this. We are seeing IPSec tunnels suddenly showing errors in the system logs that IKE phases are just deleting one right after the other and not initializing. Originally one of the tunnels actually went down and caused some issues, but it was able to be fixed via the test commands to reset the tunnels. After checking both sides of the tunnel, the configuration timing was changes to 4 hours for both Phase 1 and 2 to match the other end, as they were originally different on each end. We are still seeing partially the issue. IKE info turns red and stops showing, logs show again that the tunnel is deleting and not initializing properly. The tunnel is up in CLI and traffic is flowing, there is no outage being recorded. Not sure if this happens to be a bug or a configuration issue.

 

Any advise would go a long way.

 

Thanks.

0 REPLIES 0
  • 44 Views
  • 0 replies
  • 0 Likes
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!