New to Prisma access - Cisco to Prisma VPN question

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Announcements

New to Prisma access - Cisco to Prisma VPN question

L0 Member

Hi,

Any pointers appreciated on this. We have connectivity to Prisma via IPsec without a Cisco VTI/tunnel interface. I would like to change this so that we use Cisco VTI/tunnel at the remote access site. How do I create a VTI in Prisma access for an IPsec tunnel to a remote access network Cisco site? I am expecting somewhere to apply ip address 10.1.1.238 255.255.255.252 within Prisma so that I can ping this address from the Cisco remote access site, but it is eluding me. Is this even possible what I want do to?

 

Cisco Remote access network site config example is as follows:

interface Tunnel59
description --PA Prisma--
ip address 10.1.1.237 255.255.255.252
tunnel source x.x.x.x
tunnel mode ipsec ipv4
tunnel destination x.x.x.x
tunnel protection ipsec profile PALOPROFILE

 

Thanks in advance

 

1 REPLY 1

L0 Member

 Prisma Access VPN service is a cloudbased VPN offering, and is a VPN istcontrib:Cisco AnyConnect VPN Landing Page offering, which it will eventually replace. Frequently Asked Questions; Have Questions or Still Need Help?  As the new VPN service is a cloud-based solution, it provides the ability  

  • 4188 Views
  • 1 replies
  • 0 Likes
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!