08-15-2025 03:16 PM
Sorry for the delay, I'm in NZ, i was asleep.
Here we go!!
In the config scope, change to snippets and add a new snippet.
In the snippet configuration, head over to network and interfaces.
Add the new interfaces.
From the new interface/sub interface etc, setup any settings required. From here i create the interface (which creates the variable $ether1-20), the comment and the management profile. I do the rest (ip, port specific settings, zone, router etc) at the firewall config level.
The Variable created $ether1-20 is what gets assigned to the VR and zones either in the snippet config or in the firewall config.
From the snippet overview, change the settings for the snippet association and assign it to the firewall your configuring.
Once associated, you will see the snippet config changes made show on the candidate config for the associated firewalls, and then you can add the new interfaces to zones and VR's by the associated variable.
