About HULK

Hi, Yes, it is possible to assign IP address to tunnel interface for S-to-S VPN. If you configure the tunnel interface with an IP address and a separate security zone, you will have more clarity on the tunnel traffic. Commonly use an IP address on a tunnel interface when: a) Using VPN tunnel monitoring, ie pinging from the tunnel interface to a destination behind the remote peer b) Using dynamic routing protocols to learn routes via the tunnel interface. We cannot have an unnumbered tunnel interface to participate in dynamic routing. You can follow below mentioned discussion for the same. https://live.paloaltonetworks.com/message/13373#13373 https://live.paloaltonetworks.com/message/30175#30175 https://live.paloaltonetworks.com/message/25801#25801 Thanks ... View more

Hi Gururaj, Overlapping subnets for host IP's are supported only when they are in a separate virtual router. For example: Virtual Router1: 192.168.1.1/24 Virtual Router2: 192.168.1.2/24 Hope it will help you. Thanks ... View more

Please follow below mentioned documents for more detail information. https://live.paloaltonetworks.com/docs/DOC-1165 https://live.paloaltonetworks.com/docs/DOC-4118 https://live.paloaltonetworks.com/docs/DOC-2561 https://live.paloaltonetworks.com/docs/DOC-2011 Thanks Subhankar ... View more

This script does the indexing of  log databases, please open a case with support so that we can look into it to see why it causing the cpu to hike. ... View more

Please follow below mentioned discussion on the same topic. https://live.paloaltonetworks.com/message/29691#29691 Thanks SG ... View more

Hi, Is there any scheduled updates or any scheduled activities set on this firewall at that time. Have you observed any specific daemon taking too much of CPU... ? Thanks SG ... View more

Hi, Load-Balancing is not supported on PA platforms.You can play with Policy Based Forwarding to route/ classify certain traffic based on Network address/Applications etc through ISP-3/ISP-4 Outbound connection. Thanks Subhankar ... View more

Hi, Could you please modify the layout with appropriate IP address, it will help me to understand the requirement more in details. Thanks Subhankar ... View more

Hi, Do a "show high-availability state" from the command line. This will show you the local and the peer content versions. Verify if these match with the one from "show system info" Thanks Subhankar ... View more

HI, Could you please try "commit force" from CLI. If still the issue persists then open a ticket with support for more inspection. Thanks Subhankar ... View more

Hi, Please follow below mentioned documents for the same https://live.paloaltonetworks.com/docs/DOC-2031( page no- 94) Thanks Subhankar ... View more

Hi, You can create a Layer-3 subinterface and assign different IP address to them, hope it will help you. Thanks Subhankar ... View more

Hi, Could you please let me know what speed/duplex/state settings configured on S/W. Thanks ... View more