Arris (AT&T Fiber) to PA-220

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Announcements

Arris (AT&T Fiber) to PA-220

L1 Bithead

All,

 

I have an Arris (BGW210-700) set up as 192.168.2/24 (DHCPed) and have successfully configured the IP Passthrough to the PA-220. However, I am unable to get outbound from the PA-220. 

 

Has anyone run across this? I have the Arris going into 1/1 (as WAN), and then providing internal routing / DHCP, etc. This was working when I had Frontier / Verizon FIOS, but we switched carriers.

 

Thanks!

2 REPLIES 2

Cyber Elite
Cyber Elite

Hello,

I take it the fiber was tested with like a laptop to make sure it was active? Also are there any drops/blocks in the PAN logs? I also assume you dobule checked the PAN config in terms of the new dhcp subnet?

 

Please advise,

I was able to make it work, by forcing key Gateway and DNS settings, along with re-ip (no overlap) of the prior router.

  • 2579 Views
  • 2 replies
  • 0 Likes
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!