CLI Location command not showing the location of the IP address

cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
We are conducting regularly scheduled maintenance over the weekend, which could cause some downtime on LIVEcommunity. We apologize for any inconvenience.
Palo Alto Networks Approved
Palo Alto Networks Approved
Community Expert Verified
Community Expert Verified

CLI Location command not showing the location of the IP address

L1 Bithead

Today I found that Application and Thread ID 8559-7361 is incorrectly categorizing US IP address as if they were from China and therefore blocking all the traffic to these destinations. The only way to fix the issue was to revert back to version 8558-7356 from 4/18/22.

 

While doing the test below I could see exactly the problem:

 

JorgeOrtega_1-1650490814484.png

What is the reason for such behavior?

Additionally, if I run the same command from another firewall I don't get any location as you can see below:

JorgeOrtega_2-1650490867494.png

Any ideas why is this happening?

 

Thanks in advance.

 

Best regards,

 

Jorge.

1 REPLY 1

L5 Sessionator
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!