Enhanced Security Measures in Place: To ensure a safer experience, we’ve implemented additional, temporary security measures for all users.
06-12-2013 01:52 AM
Hello world,
I have done an upgrade of PA2050 cluster in 4.0.9 to 4.1.12. In 4.0.9 the link speed and duplex for HA PORT was forced.
after the uprade in 4.1.12 I lost a lot of packet and when I tried to do a commit I had an error message.
Commit failed because the HA PORT LINK IS NOT AUTO. I have changed the link port to auto and the issue was fixed.
I haven't see any information about this configuration do you know if this is a bug or a next pre-requisites
thks,
ALEX
06-12-2013 05:21 AM
Hi
I found following two addressed issue from 4.1.13 release note.
Does these two sound similar to your issue?
51225—When an interface was configured with hard-coded options, such as setting the duplex to full instead of auto, the interface did not come back up after a reboot. The same interface worked fine after setting it to auto negotiate. This occurred on a PA-2020 firewall and was due to an issue where the interrupts were not being properly cleared on the interfaces.
49986—The link speed and duplex settings for the dedicated HA interface on the firewall were defaulting to auto-negotiate although configured to use a specific speed and duplex value. With this fix, the dedicated HA interfaces now maintain the link speed and duplex settings defined for the interfaces.
Regards,
Emr
06-12-2013 05:21 AM
Hi
I found following two addressed issue from 4.1.13 release note.
Does these two sound similar to your issue?
51225—When an interface was configured with hard-coded options, such as setting the duplex to full instead of auto, the interface did not come back up after a reboot. The same interface worked fine after setting it to auto negotiate. This occurred on a PA-2020 firewall and was due to an issue where the interrupts were not being properly cleared on the interfaces.
49986—The link speed and duplex settings for the dedicated HA interface on the firewall were defaulting to auto-negotiate although configured to use a specific speed and duplex value. With this fix, the dedicated HA interfaces now maintain the link speed and duplex settings defined for the interfaces.
Regards,
Emr
06-12-2013 05:50 AM
thanks emr for your response.
I thinks that's exactly my problem.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
