10-08-2018 03:56 AM - edited 10-08-2018 04:06 AM
Hi Experts,
Could you please suggest how to find Relevant Zone for an IP addresses in V Wire mode.
Because in V Wire type , we don't configure IP address for that Interface, nor routing table is calcuated .Not sure, how to find the relevant Source/Destination zone(s) for an IP Addresses while creating Access rules.
Everytime, I'm looking into Monitor->Logs to find the zones. Please suggest is there any other way we could check it from GUI or from CLI.
10-08-2018 06:02 AM
Usualy you have one interface of Vwire pair in trust/lan zone and the other in untrust/internet zone. So you put zones on ingress and egress interfaces of Vwire pair.
And yeah, you will see them in logs too.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
