How to find Zone for an IP address in V Wire mode

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Announcements

How to find Zone for an IP address in V Wire mode

L2 Linker

Hi Experts,

 

 Could you please suggest how to find Relevant Zone for an IP addresses in V Wire mode.

 

 Because in V Wire type , we don't configure IP address for that Interface, nor routing table is calcuated .Not sure, how to find the relevant Source/Destination zone(s)  for an IP Addresses while creating Access rules.

 

Everytime, I'm looking into Monitor->Logs to find the zones. Please suggest is there any other way we could check it from GUI or from CLI.

 

 

1 REPLY 1

L6 Presenter

Usualy you have one interface of Vwire pair in trust/lan zone and the other in untrust/internet zone. So you put zones on ingress and egress interfaces of Vwire pair. 

And yeah, you will see them in logs too.

  • 2800 Views
  • 1 replies
  • 0 Likes
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!