how to Revert configuration by cli - pa 200 v 9.0.14

[MAerre]

Hi Guys,

we have a problem on a HA pair, the secondary firewall is no longer accessible via either GUI or CLI.
We can only connect via console, to restore one of the saved and working configurations, is it necessary to do only these commands?

> configure

# load config

+ key          key

> from         Filename

> last-saved   Last saved configuration

> partial      partial config loading

> version      Version

# commit

i can't find the correct guide other than the one that refers only to the gui.

thanks for any tip

[OtakarKlier · Accepted solution]

Hello,

Yes it is required. You have to enter configuration mode and then load the config version you would like to revert to. Once that is completed you would commit the changes.

https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000Cm9uCAC

Regards,

[MAerre · Accepted solution]

hi @OtakarKlier ,

i did the activity this morning and it worked.

tahnk you so much for the hepl!