10-27-2021 02:33 PM - edited 10-27-2021 04:11 PM
In my system logs I'm seeing the following error:
"IKE phase 1 negotiation is failed. Couldn’t find configuration for IKE phase-1 request for peer IP x.x.x.226[500]."
The bizarre thing is that the tunnel IS working despite this error!!!
The reason for the error appears to be that the IP address listed "x.x.x.226" is the wrong IP address! It should "be x.x.x.228"! I can't figure out where to go to change it! The IKE Gateway definitely has the RIGHT IP address.
Any ideas where in the configs I should go to change this wrong IP address/error showing up in the logs?
10-27-2021 05:42 PM
Highly unlikely that you are seeing the wrong IP in the logs, but whoever setup the other side of the tunnel could have misconfigured things and is sending you traffic from two different sources. I would reach out to whoever configured the other side and make sure they didn't screw up the configuration and that they don't have two configs for you (one working and one not).
10-27-2021 05:42 PM
Highly unlikely that you are seeing the wrong IP in the logs, but whoever setup the other side of the tunnel could have misconfigured things and is sending you traffic from two different sources. I would reach out to whoever configured the other side and make sure they didn't screw up the configuration and that they don't have two configs for you (one working and one not).
10-28-2021 07:44 AM
That was it! The guy on the other end had a misconfiguration and I was receiving unwanted traffic from a 2nd address. Thank you!!
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
