Interface 'configured but down'

[landoa]

Hello,

I have used interfaces in the past on a PA 3020 that were later disconnected. Those interfaces are still indicated in bright red with the message 'configured but down', including speed/duplex even though nothing is physically connected. 

As this is distracting, is it possible to reset each to simply grey and "not configured"?

Thanks

[PavelK · Accepted solution]

Thank you for the post @landoa

You can do it by following this KB: https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000Cm2CCAS

Kind Regards

Pavel

[landoa]

Dear Pavel,

That worked, thank you!