- Access exclusive content
- Connect with peers
- Share your expertise
- Find support resources
01-18-2022 07:29 AM
Hello,
I have used interfaces in the past on a PA 3020 that were later disconnected. Those interfaces are still indicated in bright red with the message 'configured but down', including speed/duplex even though nothing is physically connected.
As this is distracting, is it possible to reset each to simply grey and "not configured"?
Thanks
01-18-2022 12:23 PM
Thank you for the post @landoa
You can do it by following this KB: https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000Cm2CCAS
Kind Regards
Pavel
01-18-2022 12:23 PM
Thank you for the post @landoa
You can do it by following this KB: https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000Cm2CCAS
Kind Regards
Pavel
01-23-2022 11:47 PM
Dear Pavel,
That worked, thank you!
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!