10-20-2023 07:58 AM
Dear all,
I'm trying to set up our link monitor configuration in our 440, and I ran into an issue. Each of our physical interfaces has many subinterfaces, so the question is:
If I set up a Link monitor for a physical Interface with many subinterfaces, and only one of those subinterfaces fails, does it trigger a failover? Or do all of them have to go down for a failover to occur? Thanks!
10-20-2023 11:14 AM
You can set up path monitoring under Device > High Availability > Link and Path monitoring.
Set failure condition to "any" and configure IP from every sub-interface range to be monitored.
10-20-2023 10:21 AM
How can one subinterface fail?
10-20-2023 10:56 AM
Yes, maybe I wasn't 100% precise. Downstream, those subinterfaces correspond to physical interfaces in Switches. What I am contemplating is the case in which those physical interfaces fail.
10-20-2023 11:14 AM
You can set up path monitoring under Device > High Availability > Link and Path monitoring.
Set failure condition to "any" and configure IP from every sub-interface range to be monitored.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
