- Access exclusive content
- Connect with peers
- Share your expertise
- Find support resources
10-29-2021 08:05 AM
I found on my firewall that management interface is not able to communicate with LDAP server and so on. From the GUI it look everything is configured correctly but when I switched to CLI, I found that management interface is down.
Link status:
Runtime link speed/duplex/state: unknown/unknown/down
Configured link speed/duplex/state: auto/auto/auto
How can I turn this interface on? As I don't find the state option like for ethernet interfaces. Thank you for help
10-29-2021 08:29 AM
Check the other side of the connection where MGMT interface is connected?
Was it working before?
Also try to reseat the cable on both sides
Regards
10-29-2021 08:29 AM
Check the other side of the connection where MGMT interface is connected?
Was it working before?
Also try to reseat the cable on both sides
Regards
10-29-2021 08:58 AM
Hello,
I think that "Management interface" is just some kind of virtual interface of the firewall.
So not sure which cable to check. This firewall has only two cables connected. One for internal network which is also default gateway for the management interface, and this interface is working fine. And outside interface connected to internet which is also working.
10-29-2021 09:32 AM
What is the Model of the firewall?
Is it VM or physical?
Regards
10-29-2021 09:46 AM
it is Physical PA-220
10-29-2021 10:01 AM
Please check physical interface of PA.
Management Interface is physical interface of the firewall.
Regards
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!