Meraki behind PA850 - Site-to-site, Error Unfriendly NAT configuration

cancel
Showing results for 
Search instead for 
Did you mean: 

Meraki behind PA850 - Site-to-site, Error Unfriendly NAT configuration

L1 Bithead

Hi All, 

 

I am working on a implementation of the Meraki MXs behind PA850 - Site-to-site ( hub and spoke). I am getting error on the VPN status: NAT type: Unfriendly. This security appliance is behind a VPN-unfriendly NAT, which can be caused by upstream load balancers or strict firewall rules.

It seems to be working only when i use static one to one NAT rules. NAT type: Friendly. This security appliance is behind a VPN-friendly NAT, locally using....

It is not feasible to use static ip for every MX. 

I am hoping that someone ran into similar issue and was able to figure out the working configuration. 

 

Thanks!

Marcin

1 ACCEPTED SOLUTION

Accepted Solutions

L0 Member

In case someone comes across this as well.Meraki to Palo.jpg

 

 

View solution in original post

4 REPLIES 4

Cyber Elite
Cyber Elite

@mwiadrowski,

That's a Meraki thing and is automatic if memory serves correctly. The Meraki does a simple check to see if the source port is being modified between connections. You'll need to ensure that the NAT policy that the Meraki is using on the PA-850 maintains the same source port when it leaves the PA-850 to get this to form up properly.

@BPry 

Thank you for your reply. 

Would you provide some guidance/ KBa, how to achieve your suggested solution?

Thank you 

 

Marcin

@mwiadrowski,

So I imagine that the Meraki device simply hits a DIPP NAT rule (Dynamic IP and Port). You'll need to make another NAT policy specifically for the Meraki device that specifies the Translation Type as 'Dynamic IP' instead of 'Dynamic IP and Port'. This would allow a friendly NAT as far as the Meraki is concerned. 

L0 Member

In case someone comes across this as well.Meraki to Palo.jpg

 

 

View solution in original post

Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!