05-03-2019 09:03 AM
I am working on a implementation of the Meraki MXs behind PA850 - Site-to-site ( hub and spoke). I am getting error on the VPN status: NAT type: Unfriendly. This security appliance is behind a VPN-unfriendly NAT, which can be caused by upstream load balancers or strict firewall rules.
It seems to be working only when i use static one to one NAT rules. NAT type: Friendly. This security appliance is behind a VPN-friendly NAT, locally using....
It is not feasible to use static ip for every MX.
I am hoping that someone ran into similar issue and was able to figure out the working configuration.
05-03-2019 11:32 AM
That's a Meraki thing and is automatic if memory serves correctly. The Meraki does a simple check to see if the source port is being modified between connections. You'll need to ensure that the NAT policy that the Meraki is using on the PA-850 maintains the same source port when it leaves the PA-850 to get this to form up properly.
05-06-2019 06:55 AM
Thank you for your reply.
Would you provide some guidance/ KBa, how to achieve your suggested solution?
05-06-2019 02:18 PM
So I imagine that the Meraki device simply hits a DIPP NAT rule (Dynamic IP and Port). You'll need to make another NAT policy specifically for the Meraki device that specifies the Translation Type as 'Dynamic IP' instead of 'Dynamic IP and Port'. This would allow a friendly NAT as far as the Meraki is concerned.
In case someone comes across this as well.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!