Thank you for reply @d.spider
I went through all documentation and it always states that session offloading is supported from PA-30XX/32XX series and higher, however I was looking into one of my PA-850 and I can see: "ctd decoder bypass" for some sessions:
Even though it is not mentioned in documentation session offloading for PA-800 series seems supported.
If you determined that session offloading is not an issue in your scenario, then as Sutare mentioned maybe an issue is related to filters.
Another thing that comes to my mind is, only new sessions will be recorded after packet capture is enabled, so you will not be able to capture traffic for sessions that are already established. Also, make sure to configure all stages to be sure you do not miss anything:
Hi @d.spider ,
You don't actually need to put filter for return traffic in order to capture it. I am guessing that @PavelK was right and you don't capture on all stages. I would suggest you to take more detailed look on link that @PavelK share.
Filters in packet capture are not working, the same way you imagine. Filter is not filtering packets, it is actually used to "tag" sessions. Based on the source and destination, firewall will search its connection table and tag any session that match the filter. Packets that belongs to tagged session will be captured. Or as the previous link explain it - "filters are session aware".
So if you don't see return traffic when you use only source-to-destination filter, you definately not capturing on all stages - if I may guess not capturing transmit.
By the way, this is also very good link that, could explain why there is too much noise in your captures (even if your filter is very strict) - https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000ClgDCAS
Hi @Astardzhiev ,
The filter had all the required stages. Nothing was missing there. The filter had incorrect values. When filter point was highlighted, I referred below article while correcting the filter to make sure I am not missing anything. Here, it talks about the backup filters so I kept it.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!