PAN HA P/A with GLBP on core

cancel
Showing results for 
Search instead for 
Did you mean: 

PAN HA P/A with GLBP on core

L2 Linker

Hi Everyone,

 

Is it possible to setup a passive/active HA setup when the core switch pair are using GLBP to load balance end-user traffic ? Essentially, I will have two cores in A/A and the PANs in P/A. I am using PA-500s.

1 REPLY 1

L7 Applicator

If I understand your connectivity correctly, the answer is no.  It sounds like the two connections between the two cores where the PA will sit are A/A.  Thus you would need both PA to allow the traffic between the cores and they would need to be A/A as well.

 

When the PA is in A/P mode the interfaces on the passive device show link up but do not pass any traffic.  Only the active device in the pair will pass traffic.

Steve Puluka BSEET - IP Architect - DQE Communications (Metro Ethernet/ISP)
ACE PanOS 6; ACE PanOS 7; ASE 3.0; PSE 7.0 Foundations & Associate in Platform; Cyber Security; Data Center
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!