02-25-2013 02:19 PM
I want to set up a policy-based forwarding rule to send all traffic from a particular Source IP out through port ethernet1/8. I can't figure out how to get "1/8" in my list of interface choices. All I have to choose from is vlan, loopback and tunnel.
Thanks in advance.
02-26-2013 11:13 AM
I guess it's a layer 3 interface? I think you actually just need to set the interface type to layer 3 to be able to select it in the PBF policy. However, it wouldn't make much sense to have a L3 interface without configuring an ip-address, zone and virtual router 
02-25-2013 03:00 PM
Hi,
Have you already configured Eth1/8 with the necessary configuration. If you do not have the interface configured it will not show up under the list to choose in the PBF policy.
Hope this helps.
Thank you
02-26-2013 10:33 AM
I guess that's where my knowledge breaks down. What is the "necessary configuration"?
02-26-2013 11:13 AM
I guess it's a layer 3 interface? I think you actually just need to set the interface type to layer 3 to be able to select it in the PBF policy. However, it wouldn't make much sense to have a L3 interface without configuring an ip-address, zone and virtual router
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
