Recently purchased 2nd hand PA-3050

[AndrewWaters]

Hi All,

I recently bought a PA-3050 from my local auction house. Unfortunately I was not provided with an IP address of the MGMT interface so I am unable to connect to the device. I have gone through some of the usual default IP's however none of them appear to work.

I have connected a serial to USB cable in and gone through each baud and no luck. On 9600 I do get through to the bios windows that you can see in the screenshot, however thats all I can get to.

Any ideas on next steps?

[PavelK]

Thank you for the post @AndrewWaters

Have you tried to press either DEL or F2?

If you press F2, you should get: " Enter 'maint' for boot menu".

After you enter: "maint", you will get PANOS boot menu.

Select: PANOS (maint), then press: Continue, then you will have an option to select: "Factory Reset"

After factory reset returns: "Success" you can press: "Reboot'.

After the firewall comes up, you can login with default username and password.

You can follow below KB for management interface setup.

https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000ClS2CAK#:~:text=When%20usi....

https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000ClN7CAK

Kind Regards

Pavel

[AndrewWaters]

Hi Pavel,

thanks for getting back to me.

turns out I needed to plug a keyboard directly into the Palo so I am now able to send commands.

i press F2 or DEL and I now get promoted for a password.

i have tried usuals, admin, password, blank to no avail - any ideas?
see attached photo

[PavelK]

Thank you for reply @AndrewWaters

would it be possible to follow this KB: https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000CldXCAS

You should be able to proceed with factory reset before you get prompted for password.

Kind Regards

Pavel