Routing by source address

Showing results for 
Show  only  | Search instead for 
Did you mean: 

Routing by source address

Not applicable

Hi at all.

Actually I am migrating from a Juniper to a PAN 500, the juniper firewall has some routes based in the source address. The reason for this routes is the following, The HQ has running an ERP (SAP) in 3 servers and the conection from the remote sites to this servers is made trough a MPLS, the other traffic between the HQ and the remote sites is made trough a ipsec tunnel. What can I do to get the same results whit PAN 500 ?

Best regards


L4 Transporter

See if the attached documents help with the IPSec tunnel.

I have not used the 500 model but I know the larger models allow for Policy Based Forwarding under the policy tab and it is very straightforward to configure.

Thank you. I am going to check it.

Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!