SCCM : Clients to DP communication

cancel
Showing results for 
Search instead for 
Did you mean: 

SCCM : Clients to DP communication

L0 Member

Following is the one of prerequisites to set up a SCCM infra, is there any existing app-id that  can be used to cover this port  requirement. Will it need an explicit rule based on port/service range only  or any changes needed in  VR (IP multicast perspective) as well.  

Prerequisite :Client --> Distribution point configured for multicast, both standard and pull
Description UDP , Multicast protocol : 63000-64000.

Thanks in advance...

1 REPLY 1

Cyber Elite
Cyber Elite

you need to enable multicast in the virtual router and set the interfaces that will participate

 

you can then create a rule with destination zone set to multicast, and the port range you need to have open. (you'll see if there's a known app-ID for the traffic soon after it's set up so you can adopt app-id instead of 'any')

Tom Piens
PANgurus
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!