07-20-2012 05:15 AM
Hello,
Cause untagged sub-interface does not support in OSPF routing from v4.1.5. If I have that configuration usage in firmware before v4.1.5 (v4.1.1). What is the right way to configure OSPF area interface, if I want to keep IP address(subnet) of that sub-interface to be re-distributed in OSPF routing table?
Now, I use Loopback sub-inteface instead, cause loopback interface can only add one IP per interface(x.x.x.x/32), if my previous untagged sub-interface has subnet-mask is 24, I need to add 254 loopback sub-interfaces. Is it correct?
Thanks,
Adisorn
10-02-2012 11:40 AM
Hello, though the option to enable OSPF and RIP on untagged subinterface was being allowed in the web interface in PAN-OS versions 4.1.0 through 4.1.4 this is not supported in PAN-OS 4.1.x. Use of OSPF on untagged interfaces is not support even if configurable in the WebUI in earlier versions of PAN-OS 4.1.
10-02-2012 11:40 AM
Hello, though the option to enable OSPF and RIP on untagged subinterface was being allowed in the web interface in PAN-OS versions 4.1.0 through 4.1.4 this is not supported in PAN-OS 4.1.x. Use of OSPF on untagged interfaces is not support even if configurable in the WebUI in earlier versions of PAN-OS 4.1.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
