I am just wondering if any one could help me out on this as I am slightly lost creating and troubleshooting for the following issue:
It has been noticed that not all traffic had a user-id and it seems that any traffic originating from a VLAN goes down as “unknown” user.
So my question is, how can we make the PAN aware of the VLANS so that we can see if the change makes the users visible rather than remaining as unknown.
Hope this information helps. Looking forward to hear from you guys.
To add to this, traffic originating from 172.22.10.0/24 network on a vlan has no access to the internet as well. Looking at the traffic logs, it shows application as "incomplete". As far as I understand, incomplete traffic is when the 3-way handshake is not completed.
What has to be done to enable the completion of the 3-hand shake?
Thanks for the information. User-Identification has been checked for all the required zones. I think there is something wrong the way I have configured the NAT and Security rule. Will look into it shortly.
I will be looking into changing the route and NAT policy that is in place. What is confusing me is would this require configuring a Layer 2 network again for any specific physical interface? I was thinking on this because, I have gone through a document which helps configuring a Layer 2 to Layer 3 on the PAN Device.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!