VPN Tunnel IPSEC L2L VPN NAT not acting as intended

[alliman]

I am Labbing up a configuration I am about to go live with in production but it is not acting as it should when trying to apply a NAT rule to a tunnel interface. When I apply individual rules to the vpn traffic as I would like it to act I am not getting the intended result. I have to select bi-direction to get the NAT rule to act as it should. It works that way but it bugs me on why it is not working as intdended. 
Zones:

WAN
VPN

LAB

NAT

NAT Rules

Name	Src Zone	Dest zone	dest int	src addr	dest adds	service	src translation	dest translation
VPN-OUT	LAB	VPN	any	192.168.110.0/24	any	any	static-ip  10.0.110.0/24 bi-directional: no	none
VPN-IN	VPN	VPN	any	any	10.0.110.0/24	any	none	address 10.0.110.0/24

If I change bi-directional to yes on VPN out the both directions work. If I leave it as NO the traffic does not hit VPN-IN no matter what I do. 

any suggestions of what is going on is greatly appreciated. 

Thanks, 

Matt

[OtakarKlier]

Hello,

If you are using a bi-directional NAT. I would recommend you set it to yes. This prevent asymmetric routing and could cause applications to fail.

Here is an article that may help.

Regards,